[chef] Re: RabbitMQ startup fails because qpidd is using the same TCP port

[Mike < >]

I would argue that the Qpid daemon (used by Matahari) should be either
removed or stopped before you attempt to install Rabbit by the
operator - if it's there, the RabbitMQ cookbook should probably not
stop on anything already running.

You could write an intermediary cookbook to run before Rabbit fires
off its directives that would ensure qpidd is not going to interrupt
your flow.

Personally, I remove matahari and qpid from every system I've seen it
on. But that's entirely up to you to decide why it's there.
-M

On Thu, Dec 13, 2012 at 9:03 PM, Kenneth Stailey
<
 >
 wrote:
> Hi,
>
> I tried to install rabbitmq on RHEL 6 but by default qpidd is using
> the same TCP port.
>
> Does it make sense for the rabbitmq cookbook to stop qpidd?
>
> Thanks,
> Ken
>
> Transcript of issue:
>
>
> starting networking
> ...BOOT ERROR: FAILED
> Reason: {badmatch,
>             {error,
>                 {shutdown,
>                     {child,undefined,'rabbit_tcp_listener_sup_0.0.0.0:5672',
>                         {tcp_listener_sup,start_link,
>                             [{0,0,0,0},
>                              5672,
>                              [inet,binary,
>                               {packet,raw},
>                               {reuseaddr,true},
>                               {backlog,128},
>                               {nodelay,true},
>                               {exit_on_close,false}],
>                              
> {rabbit_networking,tcp_listener_started,[amqp]},
>                              
> {rabbit_networking,tcp_listener_stopped,[amqp]},
>                              {rabbit_networking,start_client,[]},
>                              "TCP Listener"]},
>                         transient,infinity,supervisor,
>                         [tcp_listener_sup]}}}}
> Stacktrace: [{rabbit_networking,start_listener0,4},
>              {rabbit_networking,'-start_listener/4-lc$^0/1-0-',4},
>              {rabbit_networking,start_listener,4},
>              {rabbit_networking,'-boot_tcp/0-lc$^0/1-0-',1},
>              {rabbit_networking,boot_tcp,0},
>              {rabbit_networking,boot,0},
>              {rabbit,'-run_boot_step/1-lc$^1/1-1-',1},
>              {rabbit,run_boot_step,1}]
> {"Kernel pid 
> terminated",application_controller,"{application_start_failure,rabbit,{bad_return,{{rabbit,start,[normal,[]]},{'EXIT',{rabbit,failure_during_boot}}}}}"}
> 
 
>  rabbitmq]# ps ax | grep qppid
>  7173 pts/2    S+     0:00 grep qppid
> 
 
>  rabbitmq]# ps ax | grep qpidd
>  4890 ?        Ssl    0:00 /usr/sbin/qpidd --data-dir /var/lib/qpidd 
> --daemon
>  7190 pts/2    S+     0:00 grep qpidd
> 
 
>  rabbitmq]# sudo service qpidd stop
> Stopping Qpid AMQP daemon:                                 [  OK  ]
> 
 
>  rabbitmq]# sudo chkconfig qpidd off