[chef] Re: Re: RPM Port Configuration

[Ranjib Dey < >]

on similar note, the current default configurations ship with localhost:4000 as chef_server_url, i was planning to submit a pull request, but im not sure if this is applicable for 10.x branch as well.

regards
ranjib

On Sun, Mar 3, 2013 at 10:26 AM, Sean OMeara < " target="_blank"> > wrote:

Hi.

That's because the wiki page you're looking at is for Chef 10 server.
Chef 11 runs on 80/443.

Here's an example knife config
https://gist.github.com/anonymous/528ca44c64d8986e1b19

Here's a ticket to update the wiki
http://tickets.opscode.com/browse/CHEF-3886

Here is the URL for the new docs site.
http://docs.opscode.com/

-s

On Sun, Mar 3, 2013 at 1:11 PM,  < "> > wrote:
> I wonder if someone can clarify a couple of issues when installing Open Source
> Chef Server and Workstation that I'm not clear about.
>
> I've installed Chef Server using the RPM chef-server-11.0.6-1.el6.x86_64.rpm.
> It's all installed and running perfectly, so now I'm installing the Workstation
> and I'm about to configure knife and I'm looking at;
> http://wiki.opscode.com/display/chef/Installing+Chef+Server+Manually#InstallingChefServerManually-ConfiguretheCommandLineClient
>
> It states that Chef Server is on port 4000  and Chef Server WebUI is on port
> 4040, but this appears not to be the case on the RPM install as nothing is
> listening on these two ports.  So my question is 1) What ports are they
> configured on in the RPM is installation and 2) where are these located in the
> config files?
>
> Thanks in advance.
>
> John